FORS TK6500 Bedienungsanleitung Seite 5

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 70
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 4
5
ENGLISH
Adjusting the level of conductivity
Water contains, a variable quantity of limestone and
mineral salts of which quantities vary according to
geographical locations thus varying its conductivity
values.
Relevant variations of the conductivity of the water
compared to those prefixed by the factory could
slightly influence the residual humidity of the laundry
at the end of the cycle.
Your dryer allows you to regulate the sensitivity of
the drying sensor based on conductivity values of
the water by using the following procedure.
Procedure:
Turn the programme selector dial to switch on the
appliance
In selection mode press simultaneously the buttons
3 and 6 until
«C0» appears on the digits.
Adjusting the level of conductivity:
Press the button 5 sequentially: the level of
conductivity is indicated by the lighting of the
horizontal hyphens.
6
3
2
4
5
TROCKNEN
SÉCHAGE
ABKÜHLEN
REFROIDISSEMENT
ENDE
FIN
SIEBE
FILTRES
BEHÄLTER
BAC PLEIN
KONDENSOR
CONDENSEUR
LAUFZEIT
TEMPS RESTANT
SIGNAL
AUS
A. ALARME
KURZ
RAPIDE
STARTZEIT-
VORWAHL
DÉP. DIFF.
SCHON
DÉLICAT
START/
PAUSE
M./PAUSE
6
3
12
4
5
1.25
SIGNAL
AUS
A. ALARME
KURZ
RAPIDE
TÜR
PORTE
STARTZEIT-
VORWAHL
DÉP. DIFF.
SCHON
DÉLICAT
START/
PAUSE
M./PAUSE
TROCKNEN
SÉCHAGE
ABKÜHLEN
REFROIDISSEMENT
ENDE
FIN
SIEBE
FILTRES
BEHÄLTER
BAC PLEIN
KONDENSOR
CONDENSEUR
LAUFZEIT
TEMPS RESTANT
BABYWÄSCHE
SPÉCIAL BÉBÉ
ZEIT-
PROGRAMM
MINUTERIE
AUFFRISCHEN
RAFRAÎCHIR
ABKÜHLUNG 10 min
REFROIDISSEMENT
30
60
90
SCHRANKTROCKEN
SEC
BÜGELTROCKEN
PRÊT À REPASSER
AUS
ARRET
STARKTROCKEN
SEC
SCHRANKTROCKEN
PRÊT À RANGER
LEICHTTROCKEN
LÉGÈREMENT
HUMIDE
BÜGELTROCKEN
PRÊT À REPASSER
MANGELTROCKEN
PRÊT À REPASSER
EN MACHINE
EXTRATROCKEN
TRÈS SEC
KOCHWÄSCHE, BUNTWÄSCHE
COTON
EXTRATROCKEN
TRÈS SEC
Normally, the appliance is factory-set to the
highest level; however, certain models may be
configured differently.
Memorizing the new setting:
Simultaneously press down the buttons 3 and 6 until
the previous drying cycle time appears again on the
display and the buzzer sounds.
Display
Conductivity
degree
Approximative
value (µS/cm)
CC 00
Low < 300
CC 00
Medium 300 - 600
CC 00
High > 600
125980322.qxp 2004-08-27 08:21 Page 5
Seitenansicht 4
1 2 3 4 5 6 7 8 9 10 ... 69 70

Kommentare zu diesen Handbüchern

Keine Kommentare